Featured Products for Plywood Manufacturer

Veneer Lay-up System & Glue Spreading Line

Automatic Putty Line

Plywood Finishing Line

Veneer Lathe Line

Veneer Lathe SUS

Veneer Lathe SUS

Veneer Lathe Model: SUS

The SUS veneer lathe is our flagship model having universal functions to peel high quality face and back veneer, core veneer, and even round-up peeling is possible by one unit. The SUS has been developed based on the HYPER lathe by adding the solid flat pressure bar system to the HYPER. Namely, the SUS has two pressure bars, the solid flat pressure bar and the divided pressure bar with spike disks. Typical peeling mode is 1. Round-up peeling by divided pressure bar and spike disks, 2. Face and back veneer peeling by solid flat pressure bar and 3. Core veneer peeling by divided pressure bar with spike disks till smallest diameter. Two pressure bars are switchable depending on the required veneer.

The SUS has functions of both HYPER and RF, and enables to peel all veneer sheets with high yield from small log.

The CNL type or CNS type log charger is recommendable for the SUS for highest veneer yield and productivity.

Image of Solid Pressure Bar of Veneer Lathe : SUS *Movable type Solid Pressure Bar

Image of Solid Pressure Bar of Veneer Lathe : SUS

Movable type Solid Pressure Bar During round-up peeling and peeling for core veneer, Solid Pressure Bar is over the peeling position as stand-position per the above image.

Image of Solid Pressure Bar of Veneer Lathe : SUS

On the other hand, in peeling for face veneer, Solid Pressure Bar positions in peeling position like covering Spike Disk and Divided Pressure Bar per the above image.